Information is provided by Sierra Pacific Power Co. (Nevada)
Sierra Pacific Power Company wants to ensure your safety and reduce your
frustration if an outage occurs. Listed are guidelines based on Sierra Pacific Power
Company procedures. HOW TO SHUT OFF GAS
SUPPLY
Do so ONLY if you notice structural damage to your house or
if you smell or hear leaking gas.
1. The main shut-off valve is located next to your meter on the
inlet pipe.
2. Use a crescent or pipe wrench and give the valve a quarter turn
in either direction. The valve will now run crosswise on the pipe. The line is closed.
DO NOT turn on the gas again, let the gas company do
this.
HOW TO SHUT OFF ELECTRICITY
1. Normally, most electric main disconnects (breaker/fuses) are
located with the meter on an exterior wall.
2. Look closely at your circuit breaker box or fuse-type box.
3. Be certain that you can turn off the electricity in an emergency.
DISINFECTION OF WATER
Tap water may be purified by bringing it to a rapid boil for 10
minutes. If unable to boil tap water, an alternative would be to disinfect it by the
following method:
1. Before attempting any disinfecting, first strain tap water
through a clean cloth or handkerchief to remove any sediment, floating matter or glass.
2. Tap water may be disinfected with 5.25% sodium hypochlorite
solution (e.g.: household bleach). DO NOT use solutions in which there are active
ingredients other than hypochlorite. Use the following proportions:
Clear Tap Water:
One Quart - 2 Drops
One Gallon - 8 Drops
5 Gallons - 1/2 Tsp.
Cloudy Tap Water:
One Quart - 4 Drops
One Gallon - 16 Drops
5 Gallons - 1 Tsp.
3. Mix tap water and hypochlorite thoroughly by stirring or shaking
in a container. Let stand for 30 minutes before using. A slight chlorine odor should be
detectable in the tap water. If not, repeat dosage and let stand for an additional 15
minutes.
Sierra Pacific Power Company wants to ensure your
safety and reduce your frustration if an outage occurs.
|